Mavic 2 Extension Legs #3DPrinting #3DThursday
mjhall29 shared this project on Thingiverse!
A set of extension Legs for the DJI Mavic 2.
They will give circa 52mm extra height. keep mavic out of the wet grass.
The rear legs have holes for forward facing lights (as in pictures).
Rear legs need to be clipped over the far end of the arm closest to the motor then slid into place as in photos.
it is important that the rear legs are fitted as shown as the clip is shaped.
Every Thursday is #3dthursday here at Adafruit! The DIY 3D printing community has passion and dedication for making solid objects from digital models. Recently, we have noticed electronics projects integrated with 3D printed enclosures, brackets, and sculptures, so each Thursday we celebrate and highlight these bold pioneers!
Have you considered building a 3D project around an Arduino or other microcontroller? How about printing a bracket to mount your Raspberry Pi to the back of your HD monitor? And don’t forget the countless LED projects that are possible when you are modeling your projects in 3D!
Post a Comment